PROCEED HPA 3 Manual de Instruções Página 28

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 56
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 27
Instruction Manual
D101634X012
HP and HPA Valves
October 2014
28
Figure 15. Example of Machining the Lower (Valve Plug to Seat Ring) and Upper (C-seal Plug Seal to Cage) Seating
Surfaces
UPPER SEATING
SURFACE
C-seal
RETAINER
MACHINING OF THE UPPER
SEATING SURFACE MUST
EQUALTHETOTALMACHININGOF
THE LOWER SEATING SURFACE
(PLUG PLUS SEAT RING).IF NOT,THE
RETAINER MAY STRIKE THE UPPER
SEATING SURFACE BEFORE THE
VALVE PLUG PROPERLY SEATS ON
THE LOWER SEATING SURFACE.
LOWER SEATING SURFACE
PLUS
REMOVAL OF 0.010 INCH FROM THE SEAT RING
MUST EQUAL
4.THESEVALUESAREFOR EXAMPLEONLY.REMOVE ONLY THE MINI
MUM AMOUNT OF MATERIAL REQUIRED TO REFURBISH THE SEATS.
SEAT
RING
PLUG
CAGE
A6781 /IL
1
3
2
1
2
3
NOTE:
0.508 (0.020)
(4)
0.254 (0.010)
(4)
0.254 (0.010)
(4)
REMOVAL OF 0.254 mm (0.010 inch) FROM THE VALVE PLUG
REMOVAL OF 0.254 mm (0.010 inch) FROM THE SEAT RING
REMOVAL OF0.508 mm (0.020 inch) FROM THE UPPER
SEATING SURFACE IN THE CAGE
mm (inch)
Trim Replacement (C-seal Constru ctions)
1. Apply a suitable high-temperature lubricant to the inside diameter of the C-seal plugseal.Also,lubricatethe
outside diameter of the valve plug where the C-seal plug seal must be pressed into the proper sealing position
(figure 10).
2. Orient the C-seal plug seal for correct sealing action based on the process fluid flow direction through the valve.
D The open interior of the C-seal plug seal must face up in a valve with flow-up construction (figure 10).
D The open interior of the C-seal plug seal must face down in a valve with flow-down construction (figure 10).
Note
An installation tool must be used to properly position the C-seal plug seal on the valve plug. A tool is available as a Fisher spare part
or a tool could be manufactured following the dimensions given in figure 11.
Vista de página 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Comentários a estes Manuais

Sem comentários